Tesira Operation Manual

9. Front panel interface
16
D SERIES Tesira Operation Manual rev 1.0.0
9. Front panel interface
9.1. Frame status and control
NOTE: General status indication shown in Table 9.1. For detailed information on warning and fault
indication, please refer to the Faults and Warnings table in Section 14.1.
1
ALARM LED – for frame related status indication
2
ACTIVITY LED – for amplier’s system activity status
3
STATUS LED – for the amplier’s conguration status
4
POWER LED and TOUCH BUTTON – Provides power state indication and control. Press and hold button to
toggle the amplier between ON and STANDBY state. LED indication given in Table 9.1.
9.2. Channel status and control
5
LOAD LED – Provides load related status indication for monitoring functionality of LoadSmart and LoadPilot.
Warnings and faults indicate problems or anomalies detected in the connected loudspeakers.
6
AMP LED – Provides amplier related status indication, including faults and warnings related to temperature,
over-current, clipping and very high frequency.
7
SIGNAL LED – Provides signal related status indication, including no signal and input signal clipping
8
MUTE LED and TOUCH BUTTON – Provides mute status indication and control. A single touch on the mute
button toggles the power channel mute between mute and unmuted states. Mute point is rst in the Tesira
output section for each channel.
1 2 5 6
43
7
9
8