Manualshelf

Tesira Operation Manual

ManualsBrandsLab Gruppen ManualsPower Amplifiers8000W Amplifier with 4 Flexible Output-Channels, Onboard Biamp Tesira Integration and Ethernet AVB Audio Networking for Installation Applications
31323334353637383940
12. Tesira processing environment
D SERIES Tesira Operation Manual rev 1.0.0
33
11.5.4. Indication
The LoadPilot feature constantly monitors the impedances at the two given pilot tone frequencies and compares
these to the measured thresholds. The following faults and warnings can be triggered:
• Speaker shorted warning – Both tones below lower threshold. Corresponds to a distant short circuit that can
either be in the cabling or in the speaker.
• Speaker damaged warning – One of the tones is below or above thresholds. Corresponds to an unexpected
impedance deviation of one of the tones, most likely indicating damage to the speaker.
• Under speaker count warning – Both tones above upper threshold. Corresponds to an impedance increase
across the impedance response and most likely a loss of speaker(s) in a parallel speaker connection.
• No load fault – At least one tone above measurable area or signicantly above upper threshold. Most likely
corresponding to loss of the load.
• Short circuit fault – LoadPilot analysis below short circuit threshold.
12. Tesira processing environment
12.1. Introduction
D Series Tesira variants integrate seamlessly into the Biamp Tesira network and processing environment,
functioning as high power amplication devices. For detailed information on the Tesira processing environment,
please refer to the relevant information available from Biamp Systems at www.biamp.com
13. Tutorial: Basic system configuration
This section will describe how to get started with associated software and set up a basic system for operation.
13.1. Software installation and firmware update
13.1.1. Tesira Software
1. Download Tesira Software from biamp.com: www.biamp.com/products/tesira/downloads.aspx. Locate the
Software and Firmware section and download the latest version of Tesira software.
2. Execute the installer and follow the on-screen instructions. This is a typical software installation where the
default settings are acceptable for the vast majority of users.
3. When executing the application you will be prompted to obtain a license. Biamp license their software at no
charge. Follow instructions to install. You can continue working for a limited period while waiting for the
license code.