Owner manual
13. Quick Start Tutorial
D SERIES Tesira Quick Start Guide rev 1.2.0
17
CAFÉ software
1. Download the latest CAFÉ software from www.labgruppen.com
2. Execute the installer and follow the on-screen instructions. This is a typical software installation where the
default settings are acceptable for the vast majority of users.
13.2. Network setup
Network connections/topology
The following diagram shows a typical setup with Tesira software running on a PC. A Tesira server has separate
network ports for control and AVB but D Series has these combined into one port.
Network conguration
Tesira devices are congured by default to obtain IP addresses automatically. The Tesira device will receive an
IP address automatically from a DHCP server (if present) or assign itself an IP address in the Link local range
(169.254.1.0 through 169.254.254.255). If a computer is congured the same way (which should be default on
modern operating systems), it will reside in the same subnet as the devices and communication can be established.
Control
Control/AVB
S/N
1
2
3
4
+5V
SNC-1
Secondary
Logic I/O
Primary
Secondary
Primary
1234567891011121314
100 - 240V~
50/60Hz 5.5 - 2.3A
BIAMP SYSTEMS
SERVER-IO
10
N24138
4HW3
N24138
Serial 1
Serial 2
GREEN connectors = INPUTSORANGE connectors = AEC INPUTSBLUE connectors = ANC INPUTSBLACK connectors = OUTPUTS
assembled in the USA
www.biamp.com
US: 6RMBR00BSTC-2, Complies with FCC Part 68
IC: 3184A-STC2
AVB