Instruction Manual

IPD SERIES Operation Manual rev 1.0.0

These tabs are:

i. To Recall a preset from the Device, select the preset from the drop-down menu and click/tap on

operation. (See Section 10.3)

ii. Levels - Presents facilities for setting input and output levels, setting limiters, and allows an option for

linking channels to duplicate settings. (See Section 10.4)

iii. Input EQ (1 & 2) - Presents facilities for setting parameters for the 10-band parametric input EQ.

(See Section 10.5)

iv. X-Over (Crossover) - Presents facilities for setting high- and low-pass lters for precise signal division.

(See Section 10.7)

v. Output EQ (1 & 2) - Presents facilities for setting parameters for the 10-band output parametric EQ.

Note: In Two-Way Mode, the Output EQ will show the settings of the Crossover lters.

(See Section 10.6)

10. IntelliDrive Controller Set-up and DSP Conﬁguration

10.1. Setting up and modifying ampliﬁer groups

Ampliers on the network may be set up in groups to allow easier monitoring of status and simultaneous

conguration grouped ampliers.

Note: There is no group master control panel. When a group is formed, any change in any amplier’s Mixer control

panel will affect all ampliers in the group, with resulting changes in functions and parameters determined by the

specic group conguration.

Creating a new group - From Global View, at top right corner click/tap New Group button. Enter a name for the

group and click/tap Okay. The new group will appear in Global View.

Setting up and modifying an existing group - In Global View, click/tap the SET-UP button for the group. This

opens the Congure Group window.

1. Select desired Group Status

a. When Group is Enabled, any changes will affect units in the Group as determined by Group Type.

When Disabled, any changes affect only the individual amplier unit selected.

2. Select Group Type

a. Carbon Copy - Parameters changed on any amplier in the Group will apply to all other ampliers in the

Group by default. If exceptions are desired, click on Exceptions. In the Select Exceptions window,

Active Links will be displayed. Use the drop-down tabs to add or remove parameters to be linked within

the Group.

b. Advanced Conguration - Click on Setup Links. Active Links in the Group will be displayed. No

parameters will be linked by default. Use the drop-down tabs to select any parameters to be linked

within the Group. Drop-down tab functions are (top to bottom):

i. Amplier/DSP functions

ii. Function dependent: lter number if PEQ or All selected; input number if Mixer selected

iii. Inputs and outputs

iv. Function dependent: parameters if lter selected; On and Gain if Mixer selected

9. IntelliDrive controller overview