Instruction Manual
10. IntelliDrive Controller Set-up and DSP Configuration
IPD SERIES Operation Manual rev 1.0.0
23
10.6. Output EQ and delay setting
1. Stereo mode - In stereo mode, the Output EQ and Delay allow insertion of additional lters and additional
delay. Features and operation are identical to Input EQ and Delay in Section 10.5.
2. Two-way mode - In two-way mode, the Output EQ window shows the crossover lters created in the X-Over
tab (See Section 10.7 following). Parametric output lters may be inserted as well for loudspeaker correction.
10.7. Crossover configuration
Click/tap the X-Over tab to bring up the Crossover window. The following functions are available for each output:
1. High Pass Filter type: Use the drop-down menu to select from the available lter types. Abbreviations are L-R
(Linkwitz-Riley), But (Butterworth), and Bes (Bessel).
2. Low Pass Filter type: Same as above.
3. Corner frequency setting: Set the lter corner frequency by using the slider, keyboard entry of the frequency in
the display window, or dragging the “handles” on the display graph.
Output Level metering for both outputs is displayed to monitor the effects of inserting the lters.
10.8. Preset store and recall
Presets may be stored to the device and the host computer, and recalled from either the device or the host
computer.
1. Device Store - Once a preset has been created, it may be stored to the device. It is recommended to rst
give the preset a name by entering it into the current preset name window. Click/tap on the STORE ON
DEVICE button.
2. Device Recall - Select the desired preset from the drop-down list in the Preset Selection window. Click/tap
the RECALL ON DEVICE button.
3. Computer Store - Click/tap the STORE ON COMPUTER button. Store the preset le in the desired location.
(Default is to Documents folder.) It is recommended that the preset rst be given a name by entering it into the
current preset name window and clicking Enter/Return. Then Click/Tap on the STORE ON COMPUTER button.
4. Computer Recall - Click/tap the RECALL ON COMPUTER button. Select the desired preset from the list of
available preset les and click/tap Open.
Caution - Recalling a preset while the amplier is online can cause drastic and potentially damaging changes in
output level if output mutes are not engaged and faders are at zero attenuation. It is recommended that all presets
be stored with output mutes engaged.