Operation Manual
20
IPD SERIES Operation Manual rev 2.0.0
These tabs are:
i. To Recall a preset from the Device, select the preset from the drop-down menu and click/tap on
operation. (See Section 10.3)
ii. Levels - Presents facilities for setting input and output levels, setting limiters, and allows an option for
linking channels to duplicate settings. (See Section 10.4)
iii. Input EQ (1 & 2) - Presents facilities for setting parameters for the 10-band parametric input EQ.
(See Section 10.5)
iv. X-Over (Crossover) - Presents facilities for setting high- and low-pass lters for precise signal division.
(See Section 10.7)
v. Output EQ (1 & 2) - Presents facilities for setting parameters for the 10-band output parametric EQ.
Note: In Two-Way Mode, the Output EQ will show the settings of the Crossover lters.
(See Section 10.6)
10. IntelliDrive Controller Set-up and DSP Configuration
10.1. Setting up and modifying amplifier groups
Ampliers on the network may be set up in groups to allow easier monitoring of status and simultaneous
conguration grouped ampliers.
Note: There is no group master control panel. When a group is formed, any change in any amplier’s Mixer control
panel will affect all ampliers in the group, with resulting changes in functions and parameters determined by the
specic group conguration.
Creating a new group - From Global View, at top right corner click/tap New Group button. Enter a name for the
group and click/tap Okay. The new group will appear in Global View.
Setting up and modifying an existing group - In Global View, click/tap the SET-UP button for the group. This
opens the Congure Group window.
1. Select desired Group Status
a. When Group is Enabled, any changes will affect units in the Group as determined by Group Type.
When Disabled, any changes affect only the individual amplier unit selected.
2. Select Group Type
a. Carbon Copy - Parameters changed on any amplier in the Group will apply to all other ampliers in the
Group by default. If exceptions are desired, click on Exceptions. In the Select Exceptions window,
Active Links will be displayed. Use the drop-down tabs to add or remove parameters to be linked within
the Group.
b. Advanced Conguration - Click on Setup Links. Active Links in the Group will be displayed. No
parameters will be linked by default. Use the drop-down tabs to select any parameters to be linked
within the Group. Drop-down tab functions are (top to bottom):
i. Amplier/DSP functions
ii. Function dependent: lter number if PEQ or All selected; input number if Mixer selected
iii. Inputs and outputs
iv. Function dependent: parameters if lter selected; On and Gain if Mixer selected
9. IntelliDrive controller overview