Lake Controller Operation Manual

114
Lake Controller Operation Manual Rev 1.6.1
System Store Recall Menu Reference
To compare the current conguration with one stored in a le:
1. Tap SYSTEM STORE/RECALL.
2. Navigate to the le you wish to compare.
3. Tap the le icon to select it.
4. Tap RECALL COMPARE.
5. Conrm the action by tapping the YES button in the warning message.
This function can help identify any changes that have been made since a le was recalled. Modules with
altered data are identied by a red disc behind their normal icon. This indicates that the Lake Controller is out
of sync with the device.
Figure 7-2: Module Out of Sync Identication
RECALL COMPARE does not overwrite any data in
the device. Audio will not be changed until you tap
the button labeled USE DATA IN CONTROLLER.
7.6 Recall as Virtual Sub System (SS)
The RECALL AS VIRTUAL SS button enables you to work on a system le when no physical units are
connected. All Frames are seen as virtual. Once the system has been designed, the Virtual Frames can be
replaced by physical Frames.
This function adds the Modules, Super Modules and Groups from the selected le to the current system
conguration as virtual Modules.
The button will read RECALL AS VIRTUAL SS on screen resolutions of 1024 x 768 or less; the full label
RECALL AS VIRTUAL SUB SYSTEM will be displayed on higher resolution screens.
When recalling a Dante-configured system as a Virtual Sub System, all
devices receive new default Dante Device names to ensure no conflicts
occur if the same system is recalled multiple times. Dante receivers will
subscribe to the same Dante channels prior to the virtual recall.