Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
Lake Controller Operation Manual Rev 1.6.1
Modules Menu Reference
131
8.2 . 3.1 GPI Options and Configuration (LM Series Only)
Table 8-1 lists the options available for General Purpose Input (GPI). These options can be set independently
for a transition from closed > open and from open > closed.
To change the action that occurs for a GPI command:
1. Tap the ‘Acting On’ cell for the required GPI command
2. Select the required option from the pop-up window.
3. Tap the corresponding ‘Action when transition to CLOSED’ cell
4. Select the required option from the pop-up window that is displayed
5. Tap the corresponding ‘Action when transition to OPEN’
6. Select the required option from the pop-up window that is displayed
8.2.3.2 GPO Options and Configuration (LM Series Only)
Table 8-1 lists the options available for General Purpose Output (GPO). The state when closed is user-
dened and the state when open is set to the opposite value automatically.
Table 8-1: GPO Options
Indicating State when Closed
Protective Mute State
1. Muted
2. Unmuted
Standby State
1. Standby
2. On
Fault
1. No Fault
2. Any Fault
Ready
1. Ready
2. Not Ready
No Indication -
To change the action that occurs for a GPO command:
1. Tap the ‘Indicating’ cell for GPO1 or GPO2
2. Select the required option from the pop-up window.
3. Tap the corresponding ‘State when CLOSED’ cell
4. Select the required option from the pop-up window that is displayed
‘State when OPEN‘ will be set automatically.