Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
142
Lake Controller Operation Manual Rev 1.6.1
Modules Menu Reference
8.2.7.2 Input Mixer
The Input Mixer provides the ability to mix incoming audio channels as dened by the Input Conguration,
and can be accessed from two locations:
▸ Tap the Input Mix Summary from I/O CONFIG
▸ Tap the INPUT MIXER zoom button from LEVELS
The input mixer provides gain faders and ON/OFF connection buttons as shown in Figure 8-20.
Figure 8-20: Module Input Mixer
To connect/disconnect an input, tap the button labeled ON/OFF or drag the fader. The total Module input
mix is shown on the far right of the Input Mixer window.
For Dante inputs, the receiver input channel label is displayed below the ON button.