Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
224
Lake Controller Operation Manual Rev 1.6.1
Designer Mode Menu Reference
Global Designer Mode settings are stored in the
system configuration file.
19.1.1. 2 Module
Individual EQ overlays and crossover tabs can be hidden or set to View Only. Additional settings normally
invisible in User Mode can also be adjusted and hidden at the Module level.
At the Module level, changes are specic to individual Modules and Groups. Discrete password protection
can be applied to Modules, providing an additional level of security.
19.1.1. 3 Base Configuration
Base conguration is the lowest level of Module security, enabling the system designer to dene an under-
lying base EQ curve and crossover settings along with factory levels and level limits. A system designer can
restrict what can be seen or adjusted and provide optional password protection to the underlying settings.
The Lake Controller is not shipped with base
configuration files. These can be created if required
using default Module files.
19.1. 2 Designer Mode
The functions available in Designer Mode can be used with or without password protection. By default, the
Designer Mode password is empty, allowing unprotected access to Designer Mode in a new installation of
the Lake Controller software.
To access Designer Mode:
1. From Home, tap USER PREFERENCES.
2. Tap DESIGNER FUNCTIONS.
3. Tap DESIGNER MODE.
Additional buttons on the button bar become active, providing functions specic to Designer Mode.
Figure 19-1: Accessing Designer Mode