Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
228
Lake Controller Operation Manual Rev 1.6.1
Designer Mode Menu Reference
19. 2.1.4 Base Configuration Tutorial
This tutorial illustrates important features of base conguration les, using loudspeaker Modules as the
example. For Mesa EQ Modules, use the only output available on each Module and ignore the steps regard-
ing crossovers.
To adjust levels and level limits, perform the following steps:
1. Navigate to the GAIN levels page of Module A.
2. Adjust the Output 2 gain to –9 dB.
3. Tap the DELAY button and increase Output 3 delay to 6 ms.
4. Tap METER OPTIONS, then tap LEVEL LIMITS.
5. Select GAIN/DELAY LIMITS.
6. Tap the MAX DELAY value highlighted in blue for the input channel. This is located on the left of the
screen, second from bottom, and should initially read 1800.00.
7. Enter 0 (zero), and tap OK.
Setting a maximum value identical to the minimum value removes the fader when in User Mode, or when
the base conguration le or Module is locked.
To adjust crossover settings, perform the following steps:
8. Tap the EQ tab (top left) and select XOVER (Contour) or HPF/LPF (Mesa EQ).
9. With the rst output (low frequency) selected, tap CROSSOVER SELECT.
10. Select 36 dB Butterworth from the scroll bar.
11. Tap CROSSOVER SET, then tap YES to the warning message.
12. Tap HPF ENABLE located at the top left of the screen.
13. Tap XOVER FUNCTIONS from the button bar, then tap CROSSOVER VIEW ONLY. This hides the
crossover screen or HPF/LPF screen when in User Mode, or when the base conguration/Module is
locked.
To add EQ, perform the following steps:
14. Tap PEQ1 and add a low-shelf lter around 80 Hz, with 3 dB of gain.
15. Tap HOME.