Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
Lake Controller Operation Manual Rev 1.6.1
Designer Mode Menu Reference
229
To lock the base conguration, perform the following steps:
16. Tap MODULES, then tap Module A to select it.
17. Tap LABEL & LOCK. The options shown in Figure 19-3 are displayed.
Figure 19-3: Label & Lock Menu Options
18. Tap SET BASE PASSWORD, type ‘Demo’, and tap OK.
19. Type ‘Demo’ again to conrm, and tap OK to the message.
20. Tap BASE UNLOCKED. This changes to read UNLOCK BASE and the password is now required to
unlock this base conguration le.
The XOVER page will be displayed as VIEW ONLY until it is unlocked. Any user, even a system designer,
cannot adjust the settings without rst unlocking the base conguration le.
LEVEL LIMITS and ADJUST FACTORY options are locked out in both User Mode and Designer Mode, and
the input delay fader is removed when in User Mode.
To store the new base conguration le, perform the following steps:
21. Tap LABEL EXIT, then MODULE STORE/RECALL.
22. Tap BASE CONFIGURATION.
23. Navigate to the desired folder location or create a NEW FOLDER.
24. Tap NEW STORE, enter ‘Base Cong Test’, and tap OK.
The le is stored in the folder you navigated to prior to storing, and the screen appears similar to Figure 19-4.
Figure 19-4: Storing a Base Conguration File