Lake Controller Operation Manual

230
Lake Controller Operation Manual Rev 1.6.1
Designer Mode Menu Reference
In addition to locking the crossover, HPF/LPF, and EQ of a base conguration le, the entire le can be
protected from accidental deletion.
To secure the base conguration le, perform the following steps:
25. Tap FILE UTILITIES.
26. Select the BASE CONFIG TEST base conguration le from the scroll bar.
27. Tap READ ONLY. Notice that the DELETE button is now disabled for this le.
Figure 19-5: Setting a Base Cong File to Read Only
For further protection, base configuration file utilities
are disabled when in User Mode.
To load the new base conguration le into Module B:
28. Tap FILE UTIL EXIT, then tap the Module B icon to select it.
29. Select the BASE CONFIG TEST le on the scroll bar, and tap RECALL.
30. Tap YES to the warning message.
All data changed during this tutorial is recalled into Module B, and because the base conguration was
locked, some data is now invisible or protected. Table 19-1 below describes various affected parameters.
Navigate using Module B to verify the changes made to the base conguration le.