Lake Controller Operation Manual

Lake Controller Operation Manual Rev 1.6.1
Network & Firewall Overview
23
3.6.3 Using Dante with Wireless Data Control or Low-Bandwidth Devices
Dante (Digital Audio Networking) technology requires a reliable 100 Mbps (or faster) network to operate, and
therefore cannot operate via a wireless transmitter/receiver. However, in most Lake networks, it is likely that
wireless control of the Lake devices will be required on the same network that is transmitting and receiving
Dante digital audio signals.
To achieve this, you must congure the Ethernet switch on the boundary of the wireless network to lter
Dante trafc from reaching the wireless access point or other lower bandwidth devices (e.g. legacy devices
such as the Contour Pro 26 or Mesa Quad EQ), or you will most likely experience communication problems.
The diagram below summarizes the desired outcome from correctly conguring your Ethernet switch to
lter Dante audio packet
Figure 3-12: Using Dante with Low Bandwidth devices
Please refer to the Audinate
®
document AUD-ANO-ACL Filtering SRW224G4 for further details regarding
ACL packet ltering. This document is available via:
Start > All Programs > Lake Controller vX.X > Documentation > Dante Documentation after installing the
Lake Controller software.
Additional Dante product information is available at the Audinate website: http://www.audinate.com/