Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
52
Lake Controller Operation Manual Rev 1.6.1
Lake Controller Tutorial
Figure 4-39: Adding a Parametric EQ lter on the PEQ1 Overlay
The Parametric lter tool is similar to Graphic EQ tool except the lter bandwidth is adjustable.
3. Tap and drag the red X up to boost the volume of this frequency.
Figure 4-40: Changing lter gain by dragging the lter point
4. Tap and drag either of the vertical end lines on the lter tool to increase the bandwidth as shown:
Figure 4-41: Changing the lter bandwidth using the EQ tool
5. Change the center frequency of the Parametric lter by tapping and dragging inside the vertical divider
lines of the EQ tool.