Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Global Events and Control
- 24. Keyboard Shortcuts
- 25. External Control Interfaces
- 26. Command Line Options
- 27. Firmware Update
- 28. Preset Manager
- 29. IP Address Reference
- 30. Corporate Information
Lake Controller Operation Manual Rev 1.6.1
Lake Controller Tutorial
55
Figure 4-47: Effect of Adjusting the Mesa Filter Slope
The same principle applies to the high-frequency edge (right side).
6. Tap and drag between the two center divider lines to change the frequency.
4.5 Crossovers
The Lake Controller, when used in conjunction with Contour loudspeaker Modules, allows real-time adjust-
ments to crossovers through the XOVER screen.
Crossover frequency and type and post-crossover equalization can be adjusted. In the default three-way
conguration, the Contour Module has 24 dB Linkwitz-Riley crossovers with center frequencies set at 250
Hz and 1.6 kHz. Tap the XOVER tab to view the crossover interface.
Figure 4-48: Crossover Screen
The low-output crossover is selected in this example. Use the crossover tool to change the center fre-
quency. The low and high parts of the crossover are currently combined. Tap the CROSSOVER SPLIT button