Lake Controller Operation Manual

102
Lake Controller Operation Manual Rev 1.5.8
EQ/Levels Menu Reference
CROSSOVER SET is not applicable for the Linear
Phase Brick Wall 4-Way crossover.
6.4.8.4 Filter Bypass/Filter Insert
This button reads FILTER BYPASS when a Parametric lter is selected, or when a crossover lter has been
split. For Parametric EQ lters, select the lter box and tap FILTER INSERT / FILTER BYPASS to activate or
deactivate the selected lter.
A crossover HPF/LPF lter can be disabled by splitting the crossover and tapping FILTER BYPASS, followed
by OK on the warning conrmation dialog.
Linear phase crossovers, or combined Classic
crossovers, cannot be bypassed. To bypass the
Module’s overall HPF or LPF, toggle the HPF
ENABLE / LPF ENABLE button.
6.4.9 Filter Flat
The FILTER FLAT button is active only when a PEQ lter is selected. The function is inactive if a crossover is
selected. Tap FILTER FLAT to set the lter gain to zero and leave frequency/bandwidth unchanged.
6.4.10 Filter Delete
The FILTER DELETE button is active only when a PEQ lter is selected. The function is inactive if a cross-
over is selected. Tap FILTER DELETE to remove the selected PEQ lter from the overlay.
6.4.11 Analyzer Tap to Search
Please refer to section 6.3.14 for details on this function.
6.5 Auxiliary Output Channels
Contour Modules provide various options to congure channels as auxiliary outputs. Up to 12 individually
congured auxiliary outputs can be created. The Auxiliary Output Module les allow full-bandwidth custom
settings to be congured by the user. Independent Aux tabs are provided for each output channel instead of
a unied crossover tab. These tabs are provided in addition to the input EQ overlays (PEQ/BLEQ/GEQ) that
still apply to all outputs for the Module.