Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
104
Lake Controller Operation Manual Rev 1.5.8
EQ/Levels Menu Reference
6.5.1.7 Classic 2-Way + 1-Auxiliary Outputs
The Classic 2-Way + 1-Auxiliary Outputs Module may be recalled into any Module. The other Modules of
the Frame may contain any Classic or Linear Phase Module that uses two or three output channels.
6.5.1.8 Classic 3-Way + 1-Auxiliary Outputs
The Classic 3-Way + 1-Auxiliary Outputs Module may be recalled into Module A or C. When loading this
Module type, and option to load either the Classic 2-Way or 2-Auxiliary Outputs Module into Module B/D
will be provided. No other combinations are allowed.
6.5.1.9 Linear Phase Brick Wall 2-Way + 1-Auxiliary Outputs
The Linear Phase 2-Way + 1-Auxiliary Outputs Module may be recalled into any Module. The other Modules
of the Frame may contain any Classic or Linear Phase Module that uses two or three output channels.
6.5.2 Using Auxiliary Outputs
To congure a Module for output-specic EQ, rst load an Auxiliary Output le into a Module.
1. From Home, tap MODULES.
2. Place Module A of a Frame on the MAIN page, or select an existing Module.
3. Tap MODULE STORE/RECALL.
4. Select an Auxiliary Output le from the scroll bar, and tap RECALL.
5. Read and tap YES to both warning messages.
Figure 6-19: Loading an Auxiliary Output file
6. After loading an Auxiliary Output Module le, access EQ/LEVELS for this Module by tapping
STORE/RECALL EXIT, then tap EQ/LEVELS