Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
140
Lake Controller Operation Manual Rev 1.5.8
Modules Menu Reference
Figure 8-17: Analog Iso-Float & AES Termination Summary
Software control of the Analog Iso-Float is available for Lake-enabled ampliers, along with separate control
for the analog outputs on LM Series devices. AES Termination is available for all devices except MY8-LAKE.
The current status is identied by an orange button as shown in Figure 8-18.
Figure 8-18: LM Series Analog Iso-Float & AES Termination Status
8.2.7 Input Mix Summary and Input Mixers/Switches
Input mix summaries and switches are shown on the I/O CONFIG page as part of the interactive signal path
for each Module.
8.2 .7.1 Input Mix Summary
The block diagram for each Module shows a summary of the connected inputs and associated gain settings.
The example in Figure 8-19 shows a LM Series Mesa Module.
Figure 8-19: LM Series Mesa Module Input Mix Summary and Interactive Block Diagram