Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
156
Lake Controller Operation Manual Rev 1.5.8
Modules Menu Reference
If a 2xContour module is replaced with a 4xContour module PLM+
or D Series, it is recommended to enable “Enable #Unused Page”.
This will move the unused module C&D to a new #Unused page.
Any module(s) on this page will not be displayed on the ALL page.
8.4.5 Batch Replace
This button is active (blue) regardless of whether a Module is selected in the work area. When tapped a
screen similar to Figure 8-29 is displayed.
The left side of the screen displays ofine or Virtual Frames present in the main work area. The right side of
the screen displays available online Frames on the scrollbar.
To complete the BATCH REPLACE, all online
destination Frames must be on the Module scroll
bar, and not currently in use in the work area.
Please refer to section 8.4.3.1 for detailed
information on Frame Replace rules and compat-
ibility.
Frames are sorted by Frame type (product/conguration), then by Frame name. If the product type and
Frame name match between an online and ofine Frame, a number will automatically be assigned to the
destination Frame.
Pressing the ME/SEL button on the front panel will identify the selected destination Frame with yellow
highlighting.
Please refer to the notes in section 8.4.3 for rules relating to which products are compatible with each other
for Batch Frame Replace.
If a 2xContour module is replaced with a 4xContour module PLM+
or D Series, it is recommended to enable “Enable #Unused Page”.
This will move the unused module C&D to a new #Unused page.
Any module(s) on this page will not be displayed on the ALL page.