Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
Lake Controller Operation Manual Rev 1.5.8
Modules Menu Reference
159
screen is displayed to enable conrmation of output routing - this setting can be changed by toggling the
option on the Output Conguration screen.
By default, a Module recall will remove the Module from any assigned Groups and a warning will be
displayed to conrm this action. If the Keep Group Assignment option is enabled, the assignment of the
Module to the Group will be maintained during the Module recall.
Figure 8-31: Recalling a Module File
Recalling a Module file overwrites all data currently
stored in the selected Module and if “Keep Group
Assignment” is not enabled it will also remove the
Module from any Groups.
EAW
®
Greybox
TM
file (.gyx) may also be recalled
directly into the Modules of Lake-enabled
amplifiers. Please refer to chapter 9 for further
details.
8.6.2 Store
The STORE button stores over an existing le. This button is active only when a le is selected.
1. Tap an existing le to store over (overwrite).
2. Tap STORE.
3. Conrm the action by tapping the YES button in the warning message.
If the selected file is set to READ ONLY, the STORE
function is gray (inactive).
8.6.3 New Store
The NEW STORE button stores the current Module conguration under a new le name.
1. Navigate the le system, and tap the desired destination folder to select it.
2. Tap NEW STORE.