Lake Controller Operation Manual

Lake Controller Operation Manual Rev 1.5.8
Designer Mode Menu Reference
247
Table 19-5: Output EQ Types
EQ TYPE DESCRIPTION GAIN FREQUENCY BANDWIDTH
LS Low Shelf 0 dB 125 Hz 1.9
BP
Band-pass
(Parametric)
0 dB 500 Hz 0.33
AP All Pass
2nd
Order
800 Hz 0.33
HS High Shelf 0 dB 8 kHz 1.9
19.4.4 HPF/LPF - Design (Mesa EQ Only)
Crossovers, EQ, and All Pass lters are not available on the Mesa EQ HPF/LPF - DESIGN screen. The same
HPF/LPF types are available for Mesa EQ as listed in Table 19-2.
19.4.5 Levels - Design
The data on the LEVELS - DESIGN worksheet is entered by typing the appropriate numerical value into a cell
on the worksheet. An error message will be displayed if the value is invalid or incorrect.
To set polarity through the LEVELS - DESIGN worksheet, enter either + (positive) or – (negative) in the
polarity eld. The polarity of each output can be independently locked using the LOCK POLARITY? eld,
which is only available via this worksheet.
To lock polarity of an output, change the value in the associated LOCK POLARITY? eld to Y. The example
Module in Figure 19-16 has the polarity of all channels locked except for the input and lowest output.
Figure 19-16: Locking Polarity
When the Module is locked, the worksheet will appear as shown Figure 19-17. In this example, output
polarity for channels 2, 3, and 4 will be locked even in Designer Mode.