Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
Lake Controller Operation Manual Rev 1.5.8
MY8-LAKE Reference and Operation
289
Figure 22-5: Analog Output Reference Options
The limiter compensation is active only on Host input channels (Host returns) from Contour Module outputs;
outputs from Mesa Modules, or other output types will not have this compensation applied.
22.4 I/O Configuration View Mode Options
22.4.1 Simplified View (not yet implemented)
The MY8-LAKE provides a simplied I/O routing view by default for Mesa Mode that allows simple congu-
ration of all input and output parameters. In Simplied View, the following functionality differs compared to
normal Lake Controller operation:
▸ The Digital Clock Conguration screen is disabled; the clock signal is locked by default to the same
clock as the selected input source (i.e. Host Output or AES Input). Summary data is still displayed
conrming the current automatic selection.
▸ The INPUT CONFIGURATION screen is disabled; the input type selected via the Input Toggle (Host
Output or AES Input) is set as Priority 1 for the selected Module and corresponding input (i.e. Module A
Input = Host Out 1 or AES In 1, Module B In = Host Out 2 + AES In 2, etc.)
▸ The Output Conguration screen is disabled; the Module is set to pass the processed signal to the
corresponding Host Input and AES Output (i.e. Module A = Host In 1 + AES Out 1,
Module B= Host In 2 + AES Out 2, etc.)