Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
298
Lake Controller Operation Manual Rev 1.6.0
External Control Interfaces
▸ Preset Store (not applicable for MY8-LAKE)
▸ Adjustment of amplier gain and Voltage Peak Limiter (Lake-enabled Ampliers only)
▸ Activation of LoadPilot on individual power output channels (PLM+ and D Series only)
▸ Activation of data transmission for amplier output voltage and current via Dante (Lake-enabled Ampli-
ers only
Additionally, the following parameters may be retrieved from all devices (except MY8-LAKE) using the DLM
Protocol:
▸ Preset Name, Firmware Version, Unique ID and Mac Address
▸ IP Address and Subnet Mask
▸ Dante Break-In and Enable Status
▸ Input Activity and Conguration
▸ Metering and Fault Information
▸ Current DSP > Amp Routing (Lake-enabled Ampliers only)
▸ Output channel Impedance Measurement in Ohms (PLM+ and D Series only)
These external control systems must form valid Ethernet packets that follow the requirements of the
network packet specication. Please email support@lakeprocessing.com to obtain the information required
for integration.