Lake Controller Operation Manual

Lake Controller Operation Manual Rev 1.5.8
EQ/Levels Menu Reference
73
6. 2.7.4 Assign Meters
The ASSIGN METERS function is active only when a Group levels page is accessed via a Group icon. For
metering purposes, a Module may be assigned to a Group. This provides an overview of the input/output
signals for that Group.
When a Group is created, the rst Module to be assigned to that Group is assigned to metering automati-
cally.
To assign a Module to a Group for metering purposes:
1. Access a Group LEVELS page through a Group icon.
2. Tap METER OPTIONS, then tap ASSIGN METERS.
3. The Module scroll bar appears displaying Modules assigned to the selected Group.
4. On the scroll bar, tap the Module you wish to use for metering.
5. Tap ASSIGN METERS again, then METER OPTIONS EXIT to exit this mode
6. 2.7.5 AmpClip
AmpClip provides a parameter for scaling the output metering of the Lake device to calibrate the clipping
point to a given amplier’s sensitivity. This value (the AmpClip reference level) is set in dBu and is a sum of
the factory AmpClip value (dBu) and the user AmpClip value (dB).
In both AmpClip Reference and MaxRMS Reference metering modes, the output peak meters will turn red
at the AmpClip reference level to indicate possible output clipping as shown in Figure 6-5.