Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 9. Module File Types & Lake LoadLibrary™
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
94
Lake Controller Operation Manual Rev 1.5.8
EQ/Levels Menu Reference
To add Parametric EQ to an output:
1. Tap the required crossover lter box (F) to select the crossover.
2. Use the crossover tool to select the required output of the crossover (light green is selected).
3. Tap an EQ lter (B, C, or D), and tap again in middle of screen.
4. Boost/cut the frequency gain by dragging the lter point (G) up/down.
5. Adjust the frequency by dragging the lter point (G) left or right. If FREQUENCY LOCK (A) is
active (orange), you cannot change the frequency by dragging the lter point. Either deactivate
FREQUENCY LOCK or use the EQ Tool (I) to change the frequency.
6. Adjust the bandwidth by dragging to the left or right of the shape tool (J).
6.4.4 Linear Phase Crossovers
The linear phase crossover Modules provide steep crossovers without phase distortion. Figure 6-16 shows
the XOVER screen for a Linear Phase Brick Wall 4-Way Module (LP4way).
Figure 6-16: Linear Phase Crossover Screen