Lake Controller Operation Manual
Lake Controller Operation Manual Rev 1.7.0
Modules Menu Reference
159
8.4.3 Replace Frame
The REPLACE function allows transfer of Module/Super Module/Group data between devices. If a previ-
ously used device is unavailable, or the device that performs a task is required to change, follow these
steps:
1. Tap COPY/PASTE/REPLACE from the Modules menu.
2. Tap a Module from the Frame you wish to replace on the work area.
3. Tap REPLACE FRAME
The Module scroll bar displays used and unused Modules.
4. Tap a Module from an unused Frame then tap COMPLETE REPLACE.
To locate a particular device, tap the SEL button on the front panel to center the unit on the scroll bar:
▸ LM Series | Press the top-left dynamic function button on the front panel
▸ PLM Series | Press the second dynamic function button down on the left on the front panel
▸ PLM+ Series | Press the top-left dynamic function button on the front panel
▸ D Series | Press the SELECT button to the far-right of the front panel
8.4. 3.1 Replace Frame Rules and Compatibility
▸ All Modules of a Frame must be present on the Module scroll bar (i.e. no part of the Frame can be in
use in the current system conguration)
▸ Network IP settings and Dual Redundancy conguration are not transferred during a Frame Replace
operation; congure this manually on the destination Frame.
▸ PLM 10000Q and PLM 20000Q Frames may be replaced with PLM+ or D Series, and will populate
Modules A&B only. Modules C&D will remain unaffected.
▸ PLM+ or D Series may be replaced with any product from either of these product lines without any
loss of data. If a destination model cannot set a value contained in the source model, the appropriate
minimum or maximum will be set and these discrepancies are indicated via the desired values and
actual values within brackets [ ]. These products may not be replaced by a legacy PLM product.
▸ PLM 14000 can only be replaced with an online PLM 14000.
▸ For LM Series and MY8-LAKE devices, the source and destination Frames must be of the same
conguration type (i.e. Contour, Mesa, or Contour/Mesa), and can only be replaced with a Frame of the
same product type.