Manualshelf

Lake Controller Operation Manual

ManualsBrandsLab Gruppen ManualsAudio EquipmentPower Amplifiers with DSP and Network
131132133134135136137138139140
130
Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
Dante can be enabled globally for all Dante-capable devices in the
current system conguration via Home > All > Global Info >
Events & Control > Control > Global Dante Enabled control.
Preferred Clock Master
This option identies this device as the preferred clock master device for the Dante network. To enable this
device as the Preferred Clock Master, tap this button.
This parameter is stored in System Files, and syncronizes between the Lake Controller and the Dante
Controller.
If this button is disabled when Dante is Enabled, the device is set to Dante Slave Only mode. The Dante
Slave Only mode can be viewed/edited via the Technical Data screen - refer to section 8.2.10.
Sample Rate
Dante may operate at either 48 kHz or 96 kHz; tap the appropriate button to select the preferred sample
rate.
Dante Device Name
The Copy Frame Label button copies the Frame label into the Dante Device Name parameter for this device;
after tapping this button, click OK on the on-screen keyboard to conrm the change. Alternatively the
keyboard icon may be selected to display the keyboard for manual Dante Device Name entry.
If the Dante Device Name is changed after another
device has already subscribed using the previous
name, the existing audio connection with be lost
and the other device will need to subscribe again.
When recalling a system le created before Lake
Controller v6.1, the legacy DLP-XX-XX device
names are restored to retain Dante subscriptions.
This parameter is syncronized between the Lake Controller and the Dante Controller.
Device Latency Options
This latency is additional Dante-specic latency used to ensure uninterrupted digital audio. The latency is
added to the normal latency of your chosen signal path and Module type.
The following latencies are available dependent on the device:
▸ LM, PLM+ and D Series (Gigabit Ethernet): 0.25ms / 0.50ms / 1.00ms / 2.00ms / 5.00ms
▸ PLM Series (100 Mbit Ethernet): 1.00ms / 2.00ms / 5.00ms