Lake Controller Operation Manual

140
Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
Figure 8-24: Output Conguration Screen
The left side of the screen lists the output channels for each Module. The orange numbered blocks denote
the output/s from which the signal will be sent. The same audio channel can be sent from multiple outputs,
but each digital output can contain only one channel of audio.
The following sections describe the options for SOURCE and DESTINATION. Selecting the required
SOURCE and DESTINATION values enables patching of any input or Module output to any available audio
output on the device.
8.2.8.1 Source
The arrow buttons
enable selection of the audio source. The default setting is Module Outputs,
which are the Lake device DSP channels. Depending on the device type and installed options, the source
can also be set to AES Inputs, Analog Inputs, Input Router Outputs, Dante Receivers or Host Inputs.
All Source options except Module Outputs bypass the DSP, providing pass-thru routing / signal conversion.