Network Configuration Guide
Table Of Contents
- 1 CONTENTS
- 2 INTRODUCTION
- 3.2 Dante Audio Network
- 3.1 General Networking Overview
- 3.3 Rear Panel Connections
- 4 AVOIDING SINGLE POINT OF FAILURE (SPF) ISSUES
- 5 NETWORK CONNECTIONS AND TOPOLOGIES
- 6.1 General Recommendations
- 7 REFERENCES AND DEFINITIONS
- 8 ADDITIONAL INFORMATION
4 PLM Series Network Configuration Guide
2 INTRODUCTION
From the Start menu, open the Control Panel. 1.
Under Network and Internet, choose View
Network Status and Tasks.
Underneath Network, to the right of Connection 2.
/ Local Area Connection, choose View Status.
In the dialog box, click on Properties, and click 3.
Continue in the warning dialog.
4. In the Local Area Connection Properties, 4.
select Internet Protocol Version 4 (TCP/IPv4)
and click on the Properties button below.
Proceed as in Dolby Lake Controller Manual, 5.
section 2.3.2, step 4.