Operation Manual
Table Of Contents
78
Appendix
PLM Series Operation Manual Rev 1.3.0
9.3.2 Input and Router Defaults
Autoselect: On
Input sensitivity: +26 dBu
Dante: Disabled
AES3: Terminated
Iso-Float: Enabled
Router 1: AES1 (Ch.1) as Priority 1, Analog 1 as Priority 4
Router 2: AES1 (Ch.2) as Priority 1, Analog 2 as Priority 4
Router 3: AES2 (Ch.3) as Priority 1, Analog 1 as Priority 4
Router 4: AES2 (Ch.4) as Priority 1, Analog 2 as Priority 4
Router 5: AES1 (Ch.1) as Priority 1, Analog 1 as Priority 4
Router 6: AES2 (Ch.1) as Priority 1, Analog 2 as Priority 4
Router 7: AES2 (Ch.1) as Priority 1, Analog 3 as Priority 4
Router 8: AES2 (Ch.1) as Priority 1, Analog 4 as Priority 4
9.3.3 Amplier Defaults
Attenuation: 0 dB
Polarity: Positive (In phase)
Mutes: Unmuted
Load Model: No Load Model
Breaker Emulation Limiter: 32 A - Breaker Fast (PLM 20000Q only)
9.4 Current Draw and Thermal Dissipation Specications
The tables in this section provide measured current consumption and calculated heat dissipation for ve
different operating conditions for each PLM Series device.
1. Standby Mode
2. Power On (Idle - No Signal)
3. Power On (Normal Operation - Pink Noise 1/8 of Rated Power)
4. Power On (Heavy Duty Operation - Pink Noise Max Power) - Not available for PLM 20000Q
5. Power On (Pilot Tone Operation - 20 kHz Sine Wave)