Manual
Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
135
This parameter is syncronized between the Lake Controller and the Dante Controller.
Output Channel Labeling
Tapping the keyboard button to the right of the UNI button will display the on-screen keyboard allowing up
to a 31-character name to be entered for this Dante channel.
Use alphanumeric characters (uppercase or lowercase)
and the “-” character only. DO NOT use any other
characters, especially @ . =
Entry of appropriate and meaningful channel labels on all devices is recommended before conguring
system routing. If a Dante device name or output channel label is changed on a Dante transmitter after rout-
ing to receiving devices, the channel must be disconnected and re-routed on the receiver/s to reestablish a
valid connection.
For additional information regarding Dante conguration, please refer to chapter 8.2.
As Dante uses standard Ethernet for digital audio transmission, there are certain guidelines and rules which
must be adhered to for successful implementation. Please refer to section 3.6 for further details, along with
the Dante literature included with the Lake Controller software installation.
Dante Dual Redundancy
For LM, PLM and PLM+ Series, dual redundancy is OFF by default; navigate to the TECHNICAL DATA
screen via the I/O CONFIG menu and enable if required.
For D Series, dual redundancy is ON by default; navigate to the TECHNICAL DATA screen via the
I/O CONFIG menu and disable if not required.
This change requires power cycle of the device to complete; please refer to section 8.2.10.4.
Dual redundancy status is also displayed on the Front
Panel of the device (except D Series)
8.2.6 Iso-Float Status & AES Termination
When an online device is selected the button reads Analog Iso-Float & AES Termination. When any virtual
device or an MY8-LAKE device is selected then neither option is available.