Manual

Lake Controller Operation Manual Rev 1.5.4
Modules Menu Reference
145
8.2.10.3 Dante Slave Only
If Dante Slave Only is Enabled, the device can only operate as a slave to the Dante network, and will not
be part of the Dante Clock Master selection process. It is recommended that this setting is enabled for all
devices unless the device is specically required to be part of the Dante Clock Master selection process.
This setting is enabled (ON) by default for Lake-enabled ampliers and disabled (OFF) by default for LM
Series devices.
This hardware parameter is unaffected by SYSTEM RECALL,
FRAME REPLACE, FRAME PRESET RECALL or FRAME
CONFIGURATION and SOFT RESET options. It can changed
only via this screen and via a front panel Factory Reset.
8.2.10.4 Dual Redundancy (not applicable for MY8-LAKE)
This option activates dual redundant network capabilities for Lake Controller data and Dante audio. The
secondary Ethernet port has an IP address in the 172.31.x.x range. The power must be cycled on the Lake
device to complete the change.
The Dual Redundancy option can also be viewed and changed for all devices (except MY8-LAKE) via the
Global Control Tab.
This hardware parameter is unaffected by SYSTEM RECALL,
FRAME REPLACE, FRAME PRESET RECALL or FRAME
CONFIGURATION and SOFT RESET options.
This value can only be changed via the Technical Data screen, Global Control Tab, or via a the Factory Reset
option from the device front panel.
8.2.10.5 IP Address Cong
This eld is set by default to AUTO - ZERO CONF. It can also be set to AUTO - DHCP (if a DHCP server is
used) or to a FIXED IP ADDRESS. The power must be cycled on the Lake device to complete the change.
This hardware parameter is unaffected by SYSTEM RECALL,
FRAME REPLACE, FRAME PRESET RECALL or FRAME
CONFIGURATION and SOFT RESET options.
This parameter is changed only via this screen and via the FACTORY RESET option from the front panel of
the device.