Manual

264
Lake Controller Operation Manual Rev 1.5.4
Lake-enabled Amplier Reference
Both buttons will be blue if a combination of status are present, or one button will be orange if all devices
have the same status.
Status indicators to the right of the buttons show the total number of power channels in the current system
conguration that are MUTED, UNMUTED or OFFLINE.
20.12.3 Global Temperature
The current ambient temperature (the temperature of the air surrounding the cabinets) may be entered on
this tab. Tapping on the blue button in the AMBIENT TEMPERATURE box opens a numeric keypad for the
purpose.
The temperature value is transferred to the LOADSmart Table on the MODULE LOADSmart Tab and used
for load verication and monitoring procedures. Buttons allow selection of temperature display in degrees
CELSIUS or FAHRENHEIT.
20.12.4 Global LoadSmart
The GLOBAL LOAD CONTROL VERIFY button initiates the system-wide load verication of all Frames.
20.12.5 Global Dual Redundancy Control
Two buttons, ON and OFF, control the Dual Redundancy network status of all devices that are online and
present in the current system conguration (not applicable to MY8-LAKE). A conrmation is required prior to
changing this status across all devices.
Both buttons will be blue if a combination of status are present, or one button will be orange if all devices
have the same status.
Status indicators summarize the number of online devices in the current system conguration that have this
status set to ON or OFF.
The power must be cycled on the device for this
paremeter change to complete. (i.e. disconnect or
turn off mains power then reconnect or turn on
mains power).
Please refer to section 8.2.10.4 for further information regarding Dual Redundancy.