Manual

7. Front Panel Interface
40
PLM+ SERIES Operation Manual rev 1.0.0
Note: Output limiter (gain reduction) meters take into account the sum of PLM+ ISVPL and Lake
LimiterMax.
10
The icons in the center of the LCD indicate the amplier channel to which each module output is routed. When
two amplier channels are Bridged, both channels will be displayed.
The type of icon used in the center of the screen conrms whether the PLM+ outputs are congured in Standard
mode or Bridge Mode, as shown in Figure 7.8 For further information on Bridge Mode, please refer to section
8.1.1.
Figure 7.8: Standard and Bridge Mode Front Panel Icons
Bridge Mode is visible via this icon notation on the PLM+ Front Panel in Home View, however, the Lake Controller
must be used to congure Bridge Mode; please refer to the Lake Controller Operation Manual for further
information.
Home View looks similar for most congurations, with slight variations dependant on the PLM+ model and
processor conguration.
7.10.2. Amplifier Meters View
Amplier Meters View provides further signal level information in the form of additional power output meters as
shown in Figure 7.9.
Figure 7.9: Meter Mode > Amplier Meters View
1
Output 1: V - Voltage Meter I - Current Meter P - Power Meter L - Gain Reduction Meter
2
Output 2: V - Voltage Meter I - Current Meter P - Power Meter L - Gain Reduction Meter
3
Output 3: V - Voltage Meter I - Current Meter P - Power Meter L - Gain Reduction Meter
4
Output 4: V - Voltage Meter I - Current Meter P - Power Meter L - Gain Reduction Meter
5
LoadPilot Status: 1. High Freq Pilot tone Enabled/Disabled, 2. Low Freq Pilot tone Enabled/Disabled, Status