Manual

7. Front Panel Interface

PLM+ SERIES Operation Manual rev 1.0.0

LoadPilot Status: 1. High Freq Pilot tone Enabled/Disabled, 2. Low Freq Pilot tone Enabled/Disabled, Status

Current View title & Frame label, Frame faults and warnings

• The Voltage Meter (V) indicates the power output stage voltage relative to its clip level

• The Current Meter (I) indicates the current the power output stage is driving into its load, relative to the

maximum permissible current the xed CPL allows

• The Power Meter (P) indicates the instantaneous output power being developed in the load relative to the

PLM+s maximum output power capability.

• The Gain Reduction Meter (L) indicates the degree of limiting being applied by the PLM+ ISVPL and/or the Lake

LimiterMax.

7.10.3. Temperature View

Temperature View provides information about the current operating temperatures within the PLM+. Selected fuse

type, as well as Mains Voltage and Current draw.

Figure 7.10: Meter Mode > Temperature View

Current View title. Power supply temp (PSU) & Lake processor temp (DSP) as percentage of maximum

Unused in Temperature View

Breaker Emulation Limiter; selected Fuse type - Mains Voltage - Mains Current Draw

Output 1: AMP - Temp of power output as percentage of maximum

Output 2: AMP - Temp of power output as percentage of maximum

Output 3: AMP - Temp of power output as percentage of maximum

Output 4: AMP - Temp of power output as percentage of maximum

Current View title & Frame label, Frame faults and warnings