Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
96
Lake Controller Operation Manual Rev 1.5.9
EQ/Levels Menu Reference
6.4.5.5 Crossover Copy
Copies all crossover and EQ settings from the selected XOVER or HPF/LPF page.
6.4.5.6 Crossover Paste
Active only when a crossover or HPF/LPF page has previously been copied and the current Module is the
same type.
A crossover can only be pasted to a Module of the same number of channels and the same type. For
example, a Classic 3-Way crossover can only be pasted into another Classic 3-Way crossover; the HPF/
LPF of a Mesa EQ Module can only be pasted onto another Mesa EQ HPF/LPF page; and a Classic 4-Way
crossover cannot be pasted into a Linear Phase Brick Wall 4-Way.
CROSSOVER COPY and CROSSOVER PASTE only
transfer the crossover and output EQ settings.
Levels and input EQ (PEQ/BLEQ/GEQ) will not be
transferred to the destination Module.
6.4.6 Crossover Split/Crossover Combine/Alignment Delay
This button’s label depends on the state of the currently selected crossover and the Module type. A classic
crossover Module will read CROSSOVER SPLIT / CROSSOVER COMBINE; a linear phase Module will read
ALIGNMENT DELAY.
6.4.6.1 Crossover Split
The label reads CROSSOVER SPLIT when a lter box is selected for a classic crossover that is currently
combined. This function separates the HPF and LPF of a classic crossover, enabling independent adjustment
of the crossover frequency and type.
To split a crossover, tap a crossover lter box, then tap CROSSOVER SPLIT.
CROSSOVER SPLIT is not applicable for linear
phase crossovers.