Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
166
Lake Controller Operation Manual Rev 1.5.9
Modules Menu Reference
The SM Routing screen is divided into two sections. The left side contains the interactive block diagram that
provides access to Super Module settings; the right side displays output conguration information for each
Module.
8.8.4 Label Frame
To label a Frame, perform the following steps:
1. Select a Module in the work area, or from the Super Module scroll bar if all Modules of the Frame are
already assigned to a Super Module.
2. Tap LABEL FRAME
8.8.5 De-assigning a Super Module
To de-assign a Super Module:
1. Select a Super Module in the work area and tap DE-ASSIGN MODULE [F7]
2. Tap the Module icons on the scroll bar to remove them from the Super Module
8.8.6 Remove Super Module
To remove a Super Module:
1. Tap the Super Module icon in the work area and tap REMOVE SUPER MOD.
A message appears, advising that removing the Super Module disassociates it with all the Modules
currently assigned to it.
2. Tap YES to proceed. The Super Module disappears.
A Super Module can also be removed by dragging it
to the Super Module scroll bar.