Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
204
Lake Controller Operation Manual Rev 1.5.9
Communication and Synchronization
Figure 16-3: Out of Sync Notications
▸ (A) The red disc behind the Module icon indicates that the Module is out of sync.
▸ (B) Flashing USE DATA ON PROCESSORS button.
▸ (C) Flashing USE DATA IN COMPUTER button.
▸ (D) A warning message appears that is visible from any screen in the system.
16.3.3 Updating All Devices with Computer Settings
To update all devices with the information stored in the Controller, perform the following steps:
1. From the HOME menu, tap the ashing USE DATA IN COMPUTER button.
2. Tap YES on the warning message to conrm the action.
This option may result in an audible effect, as the
data in the devices will be overwritten with the data
stored in the computer.
16.3.4 Updating the Controller with Device Settings
To update the Lake Controller with the information stored on the devices, perform the following steps:
1. From the HOME menu, tap the ashing USE DATA ON PROCESSORS button.