Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
Lake Controller Operation Manual Rev 1.5.9
Designer Mode Menu Reference
229
In addition to locking the crossover, HPF/LPF, and EQ of a base conguration le, the entire le can be
protected from accidental deletion.
To secure the base conguration le, perform the following steps:
25. Tap FILE UTILITIES.
26. Select the BASE CONFIG TEST base conguration le from the scroll bar.
27. Tap READ ONLY. Notice that the DELETE button is now disabled for this le.
Figure 19-5: Setting a Base Cong File to Read Only
For further protection, base conguration le utilities
are disabled when in User Mode.
To load the new base conguration le into Module B:
28. Tap FILE UTIL EXIT, then tap the Module B icon to select it.
29. Select the BASE CONFIG TEST le on the scroll bar, and tap RECALL.
30. Tap YES to the warning message.
All data changed during this tutorial is recalled into Module B, and because the base conguration was
locked, some data is now invisible or protected. Table 19-1 below describes various affected parameters.
Navigate using Module B to verify the changes made to the base conguration le.