Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
Lake Controller Operation Manual Rev 1.5.9
Lake-enabled Amplier Reference
253
The amplier’s meters are reproduced as vertical bar graphs. Each channel strip provides an attenuation
fader, phase reverse button, and mute button. Additional identity and status information concerning the
output channel and connected loads is shown below in two data blocks. To the right of the channel strips,
a column of control buttons provide options for displaying and enabling the mute and polarity buttons on
individual channels.
Figure 20-5: Status Tab Speaker and Power Output Channel Status
20.6.1 Attenuation
1
The virtual fader permits adjustment of the channel’s attenuation, from 0 dB (fader fully open) to - ∞dB
(fader closed). Moving this fader has the same effect as adjusting attenuation on the front panel in Menu
Mode, via MENU > ATTENUATION.