Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
256
Lake Controller Operation Manual Rev 1.5.9
Lake-enabled Amplier Reference
The Mute and Polarity enable controls are global for
all Modules currently in the work area. Controls are
reset to defaults at the start of each new session.
20.7 History Tab
A log of various optional parameters is maintained within the device. Samples are taken every two minutes.
The last 120 samples (i.e. the last 4 hours of operation) may be viewed Graphically on the HISTORY tab.
Figure 20-6: Module History Tab
20.7.1 Select Curve
The HISTORY tab displays a graph of several operational parameters against time. The vertical (Y-) axis is in
arbitrary units and is scaled from 0 to 100%; the horizontal (X-) axis is effectively ‘time’, but actually shows
the previous 120 samples taken at 2 minute intervals.
The parameter to be displayed is selected by tapping on one of the buttons in the SELECT CURVE box
below the graph. The options are: