Lake Controller Operation Manual
Table Of Contents
- 1. Welcome
- 2. Software Installation
- 3. Network & Firewall Overview
- 4. Lake Controller Tutorial
- 5. Home Menu Reference
- 6. EQ/Levels Menu Reference
- 7. System Store Recall Menu Reference
- 8. Modules Menu Reference
- 10. Groups Menu Reference
- 11. Solo/Mute Menu Reference
- 12. Icon Control Menu Reference
- 13. User Preferences Menu Reference
- 14. Pages Menu Reference
- 15. Network Menu Reference
- 16. Communication and Synchronization
- 17. Faults and Warnings
- 18. Analyzer Plug-in
- 19. Designer Mode Menu Reference
- 20. Lake-enabled Amplifier Reference
- 21. LM Series Reference and Operation
- 22. MY8-LAKE Reference and Operation
- 23. Keyboard Shortcuts
- 24. External Control Interfaces
- 25. Command Line Options
- 26. Firmware Update
- 27. Preset Manager
- 28. IP Address Reference
- 29. Corporate Information
Lake Controller Operation Manual Rev 1.5.9
Lake-enabled Amplifier Reference
271
2. Tap GLOBAL INFO.
3. Tap EVENTS & CONTROL [F8]
4. Tap the CONTROL tab
Figure 20-14: Global Control Tab
20.13.1 Global Power Control
Two buttons, ON and STANDBY, control the power status of all Lake-enabled devices (except MY8-LAKE)
that are online and present in the current system conguration. A conrmation is required prior to changing
this status across all devices.
Both buttons will be blue if a combination of status are present, or one button will be orange if all devices
have the same status.
Status indicators to the right of the buttons show the total number of LM and PLM Series devices in the
current system conguration that are ON, in STANDBY or OFFLINE.
If the Global Power Control default sequence time
is too quick, causing issues for the power distribu-
tion, this can be changed from the iC.ini file located
in the Config folder of Documents. The setting is
GLOBAL_POWER_DELAY and it is specified in ms.