Lake Controller Operation Manual

94
Lake Controller Operation Manual Rev 1.5.9
EQ/Levels Menu Reference
To add Parametric EQ to an output:
1. Tap the required crossover lter box (F) to select the crossover.
2. Use the crossover tool to select the required output of the crossover (light green is selected).
3. Tap an EQ lter (B, C, or D), and tap again in middle of screen.
4. Boost/cut the frequency gain by dragging the lter point (G) up/down.
5. Adjust the frequency by dragging the lter point (G) left or right. If FREQUENCY LOCK (A) is
active (orange), you cannot change the frequency by dragging the lter point. Either deactivate
FREQUENCY LOCK or use the EQ Tool (I) to change the frequency.
6. Adjust the bandwidth by dragging to the left or right of the shape tool (J).
6.4.4 Linear Phase Crossovers
The linear phase crossover Modules provide steep crossovers without phase distortion. Figure 6-16 shows
the XOVER screen for a Linear Phase Brick Wall 4-Way Module (LP4way).
Figure 6-16: Linear Phase Crossover Screen