Operation Manual

7. Front Panel Interface
PLM+ SERIES Operation Manual rev 3.0.4
47
7.11.1.1. Parameters with Individual Values and Group Totals
The following parameters display two values:
• MODULE > GAIN
• MODULE > DELAY
• MODULE > LIMITERS > MAXRMS LEVEL
• MODULE > LIMITERS > MAXPEAK LEVEL
The Module parameter can be adjusted using the rotary encoder. The Group total (shown in brackets) is only
adjustable using the Groups function in the Lake Controller.
The Group total is the sum of the individual Module value plus any values for this parameter on all Groups to which
the Module is assigned. Please refer to the Lake Controller Operation Manual for further information on Groups.
7.11.1.2. Menu Structure Overview
From the Main Menu, the following submenus are available, as shown in Figure 7.13 and described in the following
sections.
• MODULE (See section 7.11.2)
• Input Mixer
• Gain
• Delay
• Polarity
• Amp Gain
• Limiters
• Mute
• INPUT/OUTPUT CONFIGURATION (See section 7.11.3)
• Input Router 1 - 4
• AES Termination
• Iso-Float
• Output Router
• ATTENUATION (See section 7.11.4)
• FRAME (See section 7.11.5)
• Frame Information
• Frame Reset
• BEL Conguration
• Network
• Latency Match
• Front Panel
• FRAME PRESETS (See section 7.11.7)
• Preset Recall
7. Front Panel Interface
48
PLM+ SERIES Operation Manual rev 3.0.4
• LOAD MONITOR (See section 7.11.8)
• Congure No. of Cabinets in Parallel
• LoadSmart Verication
• Estimated No. of Cabinets
7.11.2. Module Submenu
Only module output channels for routed Power channels are displayed. This applies to all module output
congurations described below.
MENU > MODULE
After selecting the Module Menu, the screen shown in Figure 7.14 is displayed. Press the illuminated button
adjacent to the required option to view or edit the associated parameters.
Figure 7.14: Module Submenu
7.11.2.1. Input Mixer
MENU > MODULE > INPUT MIXER
Press the illuminated button next to Input Mixers A – D. Selected mixer will show four Routers (1-4) adjacent to
the right-hand buttons. Use buttons to select Router(s) and use the rotary encoder to change level values within
dened limits to congure the mixer. Multiple Routers may be selected simultaneously.
Figure 7.15: Input Mixer
7. Front Panel Interface
48
PLM+ SERIES Operation Manual rev 3.0.4