User's Manual

This document represents the latest PocketWizard functionality, the look of these menus are subject to change
3/19/2004 Using the PocketWizard options with the Kodak 14n and Kodak 14SLR v 2.1.doc
e. Setting the Zone
Zone selection is available on channels 17 – 32 only.
To set the Transmit Zone, press the up or down
portion of the NB to highlight one of the Zones A,
B, C, or D. Once the Zone is highlighted, press the
right portion of the NB to enable selection of either
ON or OFF. Use the up/down portion of the NB to
configure that Zone to ON or OFF. Once that Zone
has been configured, press the OK button. All four
Zones are configured in a similar manner.
The Receive Zone is set by selecting an appropriate Zone
and pressing OK.
f. Test Flash
Pressing the down arrow of the NB once from this position highlights the Test Flash
option. Pressing the OK button will cause any remote units that are set in receive mode
to perform a test “pop.”
Once this has been accomplished, the screen displays the results of the “Test Flash”.
The screen to the left indicates, by the display of the
lightning bolt symbol, that both radio and flash were
confirmed in zone A. Note: to detect an actual burst of
light from a flash, a PocketWizard Confirmation Sensor
must be connected to the flash. Confirmation of this
burst of light is indicated by a lighting bolt symbol on
the display. Zone B has radio confirmation but no flash
confirmation. Zone C failed because that zone is
enabled but no radio was found. Zone D is turned off.
Corrections to the setup can now be done and the system can be tested again using the
OK button on the camera or, if the CANCEL button is pressed, the menu returns to the
PocketWizard home menu.