User's Manual

Table Of Contents
· Introduction / Features
· Getting Started / Using your PocketWizard Plus
· Installing Batteries
· Connecting the Transmitter to the Camera
· Connecting the Receiver to a Flash Pack
· Connecting the Transmitter to a Local Strobe
· Transmitter and Receiver Orientation
· Care and Feeding
· Troubleshooting Guide
· Warranty
· Obtaining Technical Support
Introduction
Congratulations on your purchase of the PocketWizard Plus radio slave. This is the newest entry
in the most reliable line of radio slave products available. The PocketWizard Plus is a fully
digital radio system, making use of a microprocessor in both the transmitter and the receiver.
Digital signaling allows the PocketWizard Plus to reject spurious noise, and to receive weak
signals without any degradation in performance.
PocketWizard Plus Features
· Four selectable ID numbers (channels), compatible with the origional PocketWizard
Channels 1-4, and Chanels 1-4 on the PocketWizard Max.
· Regulated power supply - no performance degradation until low battery indication
· Digital trigger signal virtually eliminates false fires
· Sync at speeds up to 1/250 second with a focal plane shutter or 1/500 second with a lief
shutter (it takes approximately 540uS for the receiver to respond to a sync)
· Will trigger most cameras with motor drive ports
· Allows you to use a strobe you carry with you, a remote strobe, or both
· Light weight - weighs less than 4.5 ounces with batteries.
· Uses 2 AA batteries or AC adapter