User's Manual

35
B: Intervalometer (Time Lapse Photography) – /MENU A B
Enters the Intervalometer interval setting screen.
Intervalometer can be used to trigger a flash or a camera at a
set interval (time gap between triggers) for a set number of
triggers. The interval time is set in HH:MM:SS format
(Hours:Minutes:Seconds) up to a maximum of 99:59:59.
While Intervalometer is running, it will display a count
down time until the next trigger on the main screen. Also,
TRIG will be displayed on the main screen in inverse video
as the PORTs are being triggered.
1. From the main screen press /MENU A B to enter the numeric entry screen
2. Enter the interval or time gap between triggers
3. Press /MENU to proceed to the next screen
4. Enter the count or number of triggers
5. Press /MENU to return to the main screen. The interval will be displayed, and the
count will show the number of triggers to be executed.
6. Press TEST or trigger MultiMAX via Radio to begin intervalometer function
Intervalometer has two modes of operation depending on
which PORT is used:
PORT 1 = first trigger takes place AFTER first interval
PORT 2 = first trigger takes place BEFORE first interval
N
A MultiMAX (set for TRANSMIT mode) does not
send interval radio triggers. The MultiMAX (set for
TRANSMIT mode) will send out a single radio trigger
pulse at the beginning of the first interval only. It will
continue to trigger devices attached to its PORTs, but it will not send a radio trigger
for any more intervals. For remote interval operation, use interval mode on a RECEIVE
unit. Each MultiMAX (set for RECEIVE mode) may have a unique interval setting or
can be used with equal settings. Interval and count entry screens are instantly active
The Set Interval and Adjust Counter screens are instantly active. While the Set Interval
screen is displayed a change of interval will be immediately executed upon trigger either
from the TEST key or Radio trigger. The count used will be the last count set. If the
Adjust Counter screen is displayed a change of count will be immediately executed upon
trigger using the last interval set.
Î
Intervalometer can be interrupted by pressing and holding the /MENU key.
•
•
Intervalometer Mode
Set Interval Screen
Intervalometer Mode
Set Interval Screen
TRANSMIT unit
120 second Interval
36 trigger Count
TRANSMIT unit
120 second Interval
36 trigger Count