User's Manual

49
TeChnICal InforMaTIon
Specifications
Weight: 5.4 ounces with alkaline batteries
Dimensions: 1.4 inches deep x 2.1 inches wide x 4.0 inches tall (body only)
Flexible antenna = 2.4 inches tall. 0.3 inches in diameter
Batteries: 2 x AA (IEC:LR6), 1.5 V batteries, alkaline recommended
Read the Getting Started section, Page 13, for more information
ACC (Accessory Port): For AC Power use PW-AC-MX adapter
Input / Output Ports:
Size
3.5mm (1/8") mono miniphone
Port 1
Polarity sensitive (only connect properly wired cables!)
MAX Input Voltage = 250 VDC
MAX Input Current = 0.3 A
Port 2
Triggers in both polarities
Normal Polarity Specs:
MAX Input Voltage = 250 VDC
MAX Input Current = 4.0 A for 20 microseconds, 0.25 A continuous
Reverse Polarity Specs:
MAX Input Voltage = 200 VDC
MAX Input Current = 2.0 A for 20 microseconds
(pulse only, no continuous contact)
Port 1 and Hot Shoe
voltage present
Output Voltage = 3.1 VDC typical = safe for digital cameras
Port 1 and Hot Shoe
triggering threshold
< 2.2 VDC
PORT 1 and Hot Shoe
holding current:
0.0005 A
HOT SHOE NOTE: Some cameras may exhibit undesirable behavior if the RECEIVE unit is
mounted in the camera hot shoe when that camera is being fired remotely. Some cameras’
hot shoe and motor drive contacts may share some connections. This can cause the
camera to lock up or stop operating normally. If your camera does not function properly in
this mode then remove the unit from the camera’s hot shoe.