User Manual

the corresponding letter to set the desired function of the built-in speaker.
A: Beep on All Ð */MENU B B A
MultiMAX II will beep on all triggering, confirmation errors, and zero counts as indicated
below as well as on any key pressed.
B: Beep on Trigger Ð */MENU B B B
Beep on Trigger performs the same beeps as Beep On All minus the double beep when
the Counter hits zero in Count Down, Multipop, or Intervalometer modes. Unit will beep
when triggered by TEST button, PORT 1, a Radio Trigger, or the Hot Shoe per the
table.
Beep Characteristic Indicates
Single Short Beep Indicates Proper Confirmation
Single Long Beep Indicates Trigger Error
Single Very Short Beep When any Key is pressed
C: Beep on Zero / Error Ð */MENU B B C
The MultiMAX II unit will not beep on normal triggering. The MultiMAX II will beep only
when the counter reaches zero and on confirmation errors in the following manner:
Beep Characteristic Indicates
Single Long Beep Indicates Trigger Confirmation error or remote MultiMAX II (unit set
for RECEIVE mode) has reached zero count
Double Long Beep Indicates MultiMAX II has reached zero count
Single Short Beep Any Key is pressed except TEST
A MultiMAX II (set for RECEIVE mode) set to Beep on Zero / Error or set to Beep on All
will indicate a confirmation error if the unit is also set to count down and the counter
reaches zero. See the Counter section, Page 30, for more information.
D: Beep Disable Ð */MENU B B D
Turns off all beep functions. Unit will not beep.
C: LCD Contrast Adjustment Ð */MENU B C
Enters the LCD Contrast Adjustment screen. Use ?? to adjust the contrast. Contrast can
be affected by temperature. Setting the contrast to a middle setting is recommended for
most situations.
D: RESET - */MENU B D
Resets the unit to factory defaults. CLEAR/RESET is performed as if you held C on
power up (see Page 52 for more information on Factory Defaults). You will be asked to
Press C to confirm. Pressing any other key (except TEST) will cancel the reset